Loading document…
Opening in Pages for Mac...
Your browser isn’t fully supported.
For the best Pages for iCloud experience, use a supported browser.
Learn More
Cancel
Continue
JJP POTC Unboxing
Before Powerup:
◦
Locate Backbox keys
◦
Remove glass and lockbar
◦
Remove all packing materials and foam blocks
◦
Examine GOLD targets for physical binding/
sticking
◦
Examine MAP targets for physical binding/
sticking
◦
Examine shooter lane rails and remove/reform
if needed
◦
Raise playfi eld to service position
◦
Examine/seat all connectors
◦
Examine
/tighten
screw and nut for chapter
select post
and left orbit post
◦
Examine shooter tip and confi rm intact
/seated
◦
Remove chest mech and confi rm two fork
screws are tight
◦
Open backbox
◦
Confi rm CPU harness seated in backbox
First Powerup:
◦
Raise to partial service position
◦
Examine Pearl control arm travel
◦
Set to Home settings and 5 second ball save
◦
Run ship calibration test; confi rm smooth
operation of control arm
◦
Close playfi eld
◦
Run switch test on all switches, identify any
that are sticking
or failing to fi re
Final Assembly:
◦
Clean / install balls
◦
Clean playfi eld
◦
Level cabinet
at the playfi eld
◦
Install and calibrate tilt bob
◦
Adjust pearl ramp crush washer until ball will
not sit still on top of Pearl ramp
◦
Clean glass with 50/50 alcohol/distilled water
solution
◦
Test lockbar button and lubricate if sticking
◦
Replace glass and lockbar
◦
Play!